318 Chapter 10
CDMA Digital Modulation
Creating a Custom Multicarrier cdma2000 Waveform
Creating a Custom Multicarrier cdma2000 Waveform
The signal generator provides a quick and easy way to create custom multicarrier cdma2000 waveforms:
rather than building an entire 4-carrier setup from scratch, you can start with a 4-carrier cdma2000 template
and modify the template’s default values as desired.
This section teaches you how to perform the following tasks:
• “Opening the Multicarrier cdma2000 Setup Table Editor” on page 318
• “Modifying a Multicarrier cdma2000 4-Carrier Template” on page 319
• “Activating a Custom Multicarrier cdma2000 Setup” on page 320
• “Storing a Component Test Waveform to Memory” on page 316
• “Recalling a Component Test Waveform” on page 317
Opening the Multicarrier cdma2000 Setup Table Editor
1. Press Preset.
2. Press
Mode > CDMA > Arb CDMA2000 > Multicarrier Off On until On is highlighted.
3. Press
CDMA2000 Select > 4 Carriers.
4. Press
More (1 of 2) > Multicarrier Define.
This opens the Multicarrier cdma2000 Setup table editor. The 4-carrier cdma2000 template is automatically
placed in the table editor, as shown in Figure 10-7 on page 319.
To Next Page
Loading...
Need help?
General
