Chapter 4 141
Basic Digital Operation
Using Waveform Markers
6. Press Return > Name And Store > Enter.
The markers are enabled or disabled per your selections, and the changes have been saved to the selected
sequence file.
Viewing a Marker Pulse
When a waveform plays (page 109), you can detect a set and enabled marker’s pulse at the rear panel event
connector that corresponds to that marker number. This example demonstrates how to view a marker pulse
generated by a waveform segment that has at least one marker point set (page 137). The process is the same
for a waveform sequence.
This procedure uses the factory-supplied segment, SINE_TEST_WFM in the dual ARB Player.
Factory-supplied segments have a marker point on the first sample point for all four markers, as shown.
1. Press
Mode > Dual ARB > Select Waveform, and highlight the SINE_TEST_WFM segment.
2. Press
ARB Off On to On.
3. Connect the ESG’s rear-panel Q OUT output to the oscilloscope’s channel 1 input.
Sequence Marker Column
This entry shows that only
marker 3 is enabled for this
segment.
Marker points on
first sample point of
waveform segment
Viewing markers is described on page 135
To Next Page
Loading...
Need help?
General
