Chapter 16 447
W-CDMA Uplink Digital Modulation for Receiver Test
Equipment Setup
Equipment Setup
The following diagrams show the equipment setups that are used to measure the output signal generated
using the ESG. These setups are used for most of the procedures contained within this chapter and they apply
to both the PRACH and DPCH channel modes.
ESG and Agilent E4440A PSA Spectrum Analyzer Setup
Unless stated otherwise in a procedure, both the PRACH and DPCH procedures use the setup shown in
Figure 16-1 for viewing the ESG output.
Figure 16-1 PSA Setup
ESG and Base Transceiver Station (BTS) Setup
Unless stated otherwise in a procedure, both the PRACH and DPCH procedures in this chapter use the base
station setup shown in Figure 16-2. For more information on connecting the ESG to a base station, see
“Connecting the ESG to a W-CDMA Base Station” on page 552.
To Next Page
Loading...
Need help?
General
