Chapter 2 43
E4438C Vector Signal Generator Overview
Rear Panel Overview
Figure 2-5 AUX I/O Pin Configuration
14. DIGITAL BUS
This is a proprietary bus used for Agilent Baseband Studio products, which require Option 601 or 602. This
connector is not operational for general purpose customer use. Signals are present only when a Baseband
Studio option is installed (for details, refer to www.agilent.com/find/basebandstudio).
15. AC Power Receptacle
The power cord receptacle accepts a three-pronged cable that is shipped with the signal generator. The line
voltage is connected here.
View looking into
rear panel connector
To Next Page
Loading...
