Chapter 12 369
Multitone Waveform Generator
Applying Changes to an Active Multitone Signal
Recalling a Multitone Waveform
Using this procedure, you learn how to recall a multitone waveform from the signal generator’s memory
catalog.
If you have not created and stored a multitone waveform, complete the steps in the previous sections,
“Creating a Custom Multitone Waveform” on page 366 and “Storing a Multitone Waveform” on page 368,
then preset the signal generator to clear the stored multitone waveform from volatile ARB memory.
1. Press
Mode > Multitone.
2. Press
More (1 of 2) > Load/Store.
3. Highlight the desired file (for example, 5TONE).
4. Press
Load From Selected File > Confirm Load From File.
5. Press
More (2of 2) > Multitone Off On until On is highlighted.
The firmware generates the multitone waveform in ARB memory. After waveform generation, the multitone
waveform is available to be modulated on the RF output.
For instruction on configuring the RF output, see “Configuring the RF Output” on page 367.
To Next Page
Loading...
Need help?
General
