Chapter 10 333
CDMA Digital Modulation
cdma2000 Reverse Link Modulation for Receiver Test
Configuring the RF Output
The steps in this procedure build upon the previous procedure.
1. Set the RF output frequency to 2.14 GHz.
2. Set the output amplitude to −30 dBm.
3. Press
RF On/Off to On.
The user defined, real-time reverse link cdma2000 signal is now available at the signal generator’s RF
OUTPUT connector.
To store this real-time I/Q baseband digital modulation state to the instrument state register, see “Saving an
Instrument State” on page 71.
To recall a real-time I/Q baseband digital modulation state, see “Recalling an Instrument State” on page 72.
To Next Page
Loading...
