Agilent Technologies E4438C User Manual

402 Chapter 14
Real Time TDMA Formats
DECT Framed Modulation
Configuring the RF Output
1. Set the RF output frequency to 1.89 GHz.
2. Set the output amplitude to −10 dBm.
3. Press
RF On/Off to On.
The user-defined DECT signal is now available at the signal generator’s RF OUTPUT connector.
To store this real-time I/Q baseband digital modulation state to the instrument state register, see “Saving an
Instrument State” on page 71.
To recall a real-time I/Q baseband digital modulation state, see “Recalling an Instrument State” on page 72.

Agilent Technologies E4438C Specifications

General

Brand	Agilent Technologies
Model	E4438C
Category	Portable Generator
Language	English