Chapter 10 321
CDMA Digital Modulation
Creating a Custom Multicarrier cdma2000 Waveform
After waveform generation, the new multicarrier cdma2000 waveform is stored in volatile memory. The
CDMA2K and I/Q annunciators appear on the display and the RF ON annunciator replaces the RF OFF
annunciator, as shown in the following figure. The modulated signal is now present at the RF OUTPUT
connector.
To store a custom multicarrier waveform, refer to “Storing a Component Test Waveform to Memory” on
page 316.
To recall a custom multicarrier waveform, refer to “Recalling a Component Test Waveform” on page 317.
To Next Page
Loading...
