6 Sample Sessions: Other Mini-OTDR Modes How to set up a Multi Fiber Test
152 E6000C Mini-OTDR User’s Guide, E0302
9 Start a new trace by pressing the R
UN/STOP key. The
new trace is made with the settings that you have
previously saved.
NOTE For more details about the facilities available in
EasyMode, see “EasyMode” on page 62.
How to set up a Multi Fiber Test
Multi Fiber Test Mode allows you to measure and save
many traces on different fibers with up to four different
measurement setups per fiber.
You can save a setup as a setting (*.SET), template
(*.TPL), or Trace (*.SOR) file, then measure a series of
fibers with these presaved parameters.
For details on how to save a file, see “How to Save the
Measurement” on page 104, or “How to Save a Template”
on page 150.
How to Navigate within the Multi Fiber Test
Config page
Multi Fiber Test mode 1 Select Multi Fiber Test from the Applications screen.
You see the Mutifiber Test Configuration screen (Figure
57). The page that you see is the one visited last in this
Configuration screen.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
