3 Sample Sessions: Measuring a Trace How to Make an Automatic Measurement
84 E6000C Mini-OTDR User’s Guide, E0302
6 Move to OK in the Measurement Settings menu and
press the S
ELECT key.
NOTE Parameters changed in the [S
ETTINGS] page only affect
subsequent traces. The current trace is unaltered.
If you alter the settings while a measurement is running,
press R
UN/STOP again to start a new trace with the
parameters that you have just set.
NOTE You can alter the Refractive Index Setting for just the
current trace by selecting <A
DJUST REFR.IND/DIST> from
the [A
NALYSIS] menu.
How to Make an Automatic
Measurement
NOTE Before you run a trace, you may want to make the correct
settings and configure your instrument.
See “How to Change the Refractive Index Setting” on
page 82, “How to Set the General Configuration” on
page 130, “How to Set the OTDR Settings” on page 134,
and “How to Set the Trace Information” on page 136.
To let the Mini-OTDR set up itself for the measurement:
1 Select [S
ETTINGS] from the OTDR Mode popup panel.
2 If you are not already viewing the Meas. Parameter
page (Figure 12), cursor to either of the arrows at the
bottom left of the screen. Press S
ELECT to bring up the
next page.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
