Additional Cleaning Information E Cleaning Information
E6000C Mini-OTDR User’s Guide, E0302
297
How to clean large area lenses and mirrors
Some mirrors, as those from a monochromator, are very
soft and sensitive. Therefore, never touch them and do
not use cleaning tools such as compressed air or polymer
film.
Coated lenses Some lenses have special coatings that are sensitive to
solvents, grease, liquid and mechanical abrasion. Take
extra care when cleaning lenses with these coatings.
Multiple lenses Lens assemblies consisting of several lenses are not
normally sealed. Therefore, use as little liquid as possible,
as it can get between the lenses and in doing so can
change the properties of projection.
Preferred Procedure
Use the following procedure on most occasions.
1 Blow away any dust or dirt with compressed air.
Procedure for Stubborn Dirt
Use this procedure particularly when there is greasy dirt
on the lens:
CAUTION Only use water if you are sure that your device does not
corrode. Do not use hot water as this can lead to
mechanical stress, which can damage your device.
Make sure that your liquid soap has no abrasive
properties or perfume in it, because they can scratch and
damage your device.
Do not use normal washing-up liquid as sometimes an
iridescent film remains.
1 Moisten the lens or the mirror with water.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
