E Cleaning Information Additional Cleaning Information
298 E6000C Mini-OTDR User’s Guide, E0302
2 Put a little liquid soap on the surface and gently spread
the liquid over the whole area.
3 Wash off the emulsion with water, being careful to
remove it all, as any remaining streaks can impair
measurement accuracy.
4 Take a new, dry soft-tissue and remove the water, by
rubbing gently over the surface using a small circular
movement.
5 Blow away remaining lint with compressed air.
Alternative Procedure A
To clean lenses that are extremely sensitive to mechanical
stress or pressure you can also use an optical clean
polymer film. This procedure is time-consuming, but you
avoid scratching or destroying the surface.
1 Put the film on the surface and wait at least 30 minutes
to make sure that the film has had enough time to dry.
2 Remove the film and any dirt with special adhesive
tapes.
Alternative Procedure B
If your lens is sensitive to water then:
1 Moisten the lens or the mirror with isopropyl alcohol.
2 Take a new, dry soft-tissue and remove the alcohol,
dissolved sediment and dust, by rubbing gently over the
surface using a small circular movement.
3 Blow away remaining lint with compressed air.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
