E6000C Mini-OTDR User’s Guide, E0302 219
D
D Single-Mode/Multimode Module
Performance Tests
The procedures in this section tests the optical
performance of the instrument. The complete
specifications to which the Agilent Technologies E6000C
is tested are given in “Specifications” on page 191.
All tests can be performed without access to the interior
of the instrument. The performance tests refer
specifically to tests using the Diamond Agilent/HMS-10
connector.
General
Equipment Required
Equipment required for the performance test is listed
below. Any equipment meeting the same specifications
can be used.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
