3 Sample Sessions: Measuring a Trace How to Run a Manual Measurement
86 E6000C Mini-OTDR User’s Guide, E0302
How to Run a Manual
Measurement
When you already know about the fiber under test, you
can set the parameters exactly. This section describes
how to setup and run a measurement manually.
How to Change the Measurement Span
1 Select [SETTINGS] from the OTDR Mode popup panel.
2 If you are not already viewing the Meas. Parameter
page (Figure 12), cursor to either of the arrows at the
bottom left of the screen. Press S
ELECT to bring up the
next page.
Select Range 3 Move to <R
ANGE> and press SELECT. You see a list of
preset typical ranges.
4 Highlight a preset range and press S
ELECT.
Alternatively:
♦ Select <R
ANGE INPUT>, and use the Cursor keys to
control the start and span values.
NOTE If you want the Mini-OTDR to select a suitable range for
your fiber, you can select Auto at the bottom left of the
Settings screen.
How to Change the Optimization Mode
1 If you are not still in the Measurement Settings
menu, select [S
ETTINGS] from the popup panel.
2 If you are not already viewing the Meas. Parameter
page (Figure 12), cursor to either of the arrows at the
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
