Agilent Technologies E6000C - How to Perform an Insertion Loss Measurement

6 Sample Sessions: Other Mini-OTDR Modes How to Perform an Insertion Loss Measurement
168 E6000C Mini-OTDR User’s Guide, E0302
You have now selected Code modulation. You can use
Code modulation when you have connected the power
meter submodule to another source (such as a second
Mini-OTDR), and you want to use the wavelength of this
source.
NOTE Code is equivalent to selecting the Dual
λ or Single λ
mode from the Agilent N3974 handheld Dual Laser
Source.
How to Perform an Insertion
Loss Measurement
How to Set up the Power Meter
Insert submodule 1 Install a Power Meter submodule, and select the Power
Meter screen (see “How to Use the Power Meter
Submodule” on page 165).
Set CW mode 2 Cursor to Mod. on the Source (right-hand) diagram.
Press S
ELECT until you see CW in the Source window.
Select Wavelength 3 Staying in the right-hand diagram, cursor U
P to λ. Press
S
ELECT until you see the correct wavelength for your
measurement in the Power Meter window.
4 Cursor Left to the Power Meter (left-hand) diagram.
Select
λ until the wavelength in the power meter
window is the same as the wavelength you have
selected for the Source.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com