How to set up a Multi Fiber Test 6 Sample Sessions: Other Mini-OTDR Modes
E6000C Mini-OTDR User’s Guide, E0302
155
4 Modify the settings as you would from the OTDR Mode
Settings page.
See “How to Change the Refractive Index Setting” on
page 82 for an example of how to change the settings.
5 When you have changed all the settings you want, select
OK
.
NOTE If you try to modify a .SOR or .TPL file, you see an error
message saying that this is not possible.
How to change the file name
Default file name The measurements are saved to a file. By default, the
name of this file is derived from the Measurements
name, and the fiber number.
For example, if you use the measurements from
DEMO.SOR with a fiber numbered 100, the saved trace will
have the default name DEMO_100.SOR. This default name
is written in the appropriate Save As... column.
You can select a different name as follows:
Save with new name 6 Cursor to the Save As.. edit field next to the
measurement you have just set.
7 Press S
ELECT.
You see a screen keyboard, containing the current Save
As name.
8 Use the screen keyboard to enter a new name.
You see a highlighted point in the edit field, where
characters are inserted or deleted. Use the left and
right cursors to move this point, which is still
highlighted when you cursor down to new characters
or the Del button.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
