CHAPTER 5 REFERENCE GUIDE
EFD1000/500 MFD Pilot’s Guide
Page 5-48 091-00006-001 REV B
EFD1000/500 MFD Pilot’s Guide
Page 5-49091-00006-001 REV B
5.2.9.2. Status Message
Message Description
Activation Required The XM receiver is indicating that the receiver is not activated. Follow the instructions to activate the receiver.
Antenna Failure The XM receiver is reporting that no antenna is connected.
Data Unavailable The receiver has tuned to the satellite, but data is not available (such as: o the air, weak signal condition, or service
blocked for some reason).
No Communications The XM receiver is not communicating with the EFD. Continued failure to power up would most likely mean an issue
with power to the receiver, the connection between the EFD and receiver, or the XM receiver itself.
No Service No Service is available
No Signal The XM receiver is indicating the No Signal has been found
Operational The XM receiver is initialized and ready to received data
Powering Up The XM receiver is in the process of initializing. If the receiver does not communicate or fails to initialize, the EFD will
attempt to power up again after 15 seconds. Continued failure to power up would most likely mean an issue with power
to the receiver, the connection between the EFD and receiver, or the XM receiver itself.
Saving Cong Periodically, the unit’s conguration is saved (such as subscription data) and reboots. This is done automatically and is
synced by XM such that no weather data products are lost during the cycling.
Tuning The XM receiver is attempting to locate the satellite and tune to the correct channel to receive the weather products. If
this state persists, then it could mean a broken or disconnected antenna, or the satellite signal is being obstructed.
Unknown Error An error has been indicated, but the receiver does not specify what the error is.
XM Error Indicated The XM receiver has indicated that there is an error, but did not specify the source of the error.
Table 5-12 XM Status Messages
To Next Page
Loading...