Notes:
• If the Internal SRV table is configured, the device initially attempts to
resolve a domain name using this table. If the domain name isn't found,
the device performs a Service Record (SRV) resolution using an external
DNS server configured in the Multiple Interface table (see 'Configuring IP
Network Interfaces' on page 113).
• The Internal SRV table can also be configured using the table ini file
parameter, SRV2IP (see 'DNS Parameters' on page 759) or CLI
command, configure voip > control-network dns srv2ip.
To configure the Internal SRV table:
1. Open the Internal SRV Table page (Configuration tab > VoIP menu > Network
submenu > DNS submenu > Internal SRV Table).
2. Click Add; the following dialog box appears:
Figure 14-6: Internal SRV Table Page
3. Configure the SRV rule, as required. For a description of the parameters, see the table
below.
4. Click Submit; the SRV rule is added to the table.
Internal SRV Table Parameter Description
Parameter Description
Domain Name
CLI: domain-name
[Srv2Ip_InternalDomain]
Defines the host name to be translated.
The valid value is a string of up to 31 characters.
To Next Page
Loading...
