AudioCodes Media 800 MSBR

User's Manual 900 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
the next trunk. Note that initially, the device attempts to
recover the clock from the trunk defined by the parameter
TDMBusLocalReference.
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is relevant only if the parameter
TDMBusClockSource is set to 4.
Web: TDM Bus PSTN Auto
Clock Reverting
EMS: TDM Bus Auto Fall Back
Reverting Enable
[TDMBusPSTNAutoClockRev
ertingEnable]
Enables the PSTN trunk Auto-Fallback Reverting feature. If
enabled and a trunk returning to service has an
AutoClockTrunkPriority parameter value that is higher than the
priority of the local reference trunk (set in the
TDMBusLocalReference parameter), the local reference reverts
to the trunk with the higher priority that has returned to service for
the device's clock source.
 [0] Disable (default)
 [1] Enable
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only when the
TDMBusPSTNAutoClockEnable parameter is set to 1.
Web: Auto Clock Trunk Priority
EMS: Auto Trunk Priority
CLI: clock-priority
[AutoClockTrunkPriority]
Defines the trunk priority for auto-clock fallback (per trunk
parameter).
 0 to 99 = priority, where 0 (default) is the highest.
 100 = the SW never performs a fallback to that trunk (usually
used to mark untrusted source of clock).
Note: Fallback is enabled when the
TDMBusPSTNAutoClockEnable parameter is set to 1.
66.11.6.3 CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
Note that CAS is not applicable to BRI interfaces.
CAS Parameters
Parameter Description
Web: CAS Transport Type
EMS: CAS Relay Transport
Mode
CLI: CAS-transport-type
[CASTransportType]
Determines the ABCD signaling transport type over IP.
 [0] CAS Events Only = (Default) Disable CAS relay.
 [1] CAS RFC2833 Relay = Enable CAS relay mode using RFC
2833.
The CAS relay mode can be used with the TDM tunneling feature
to enable tunneling over IP for both voice and CAS signaling
bearers.
[CASAddressingDelimiters]
Enables the addition of delimiters to the received address or
received ANI digits string.
 [0] = (default) Disable. The address and ANI strings remain
without delimiters.
 [1] = Enable. Delimiters such as '*', '#', and 'ST' are added to
the received address or received ANI digits string.