AudioCodes Media 800 MSBR

User's Manual 316 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
CLI: suffix-to-add
[Suffix2Add]
redirect number. For example, if you enter 00 and the redirect number
is 1234, the new number is 123400.
Web: Presentation
EMS: Is Presentation
Restricted
CLI: is-presentation-
restricted
[IsPresentationRestricted
]
Enables caller ID.
 Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 404).
 [0] Allowed = Sends Caller ID information when a call is made
using these destination / source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Notes:
 If 'Presentation' is set to 'Restricted' and the AssertedIdMode
parameter is set to Add P-Asserted-Identity, the From header in
the INVITE message includes the following: From: 'anonymous'
<sip: anonymous@anonymous.invalid> and 'privacy: id' header.
Web: TON
EMS: Number Type
CLI: ton
[NumberType]
Defines the Type of Number (TON).
The default is 'Unknown' [0].
 If you select 'Unknown' for the NPI, you can select Unknown [0].
 If you select 'Private' for the NPI, you can select Unknown [0],
International [1], National [2], Network Specific [3] or Subscriber
[4].
 If you select 'E.164 Public' for the NPI, you can select Unknown
[0], International [1], National [2], Network Specific [3], Subscriber
[4] or Abbreviated [6].
Notes:
 This parameter is applicable only to the Redirect Number IP > Tel
table.
 For more information on available NPI/TON values, see
Numbering Plans and Type of Number on page 325.
Web: NPI
EMS: Number Plan
CLI: npi
[NumberPlan]
Defines the Numbering Plan Indicator (NPI).
 [0] Unknown (default)
 [9] Private
 [1] E.164 Public
 [-1] Not Configured = value received from PSTN/IP is used
Notes:
 This parameter is applicable only to the Redirect Number IP > Tel
table.
 For more information on available NPI/TON values, see
Numbering Plans and Type of Number on page 325.
25.6 Manipulating Redirected and Diverted Numbers for
Call Diversion
You can configure manipulation rules to manipulate the Diverted-to and Diverting numbers
received in the incoming Call Redirection Facility message for call diversion, which is
interworked to outgoing SIP 302 responses. This feature is applicable to the Euro ISDN
and QSIG variants, and to IP-to-Tel calls.
The incoming redirection Facility message includes, among other parameters, the
Diverted-to number and Diverting number. The Diverted-to number (i.e., new destination) is
mapped to the user part in the Contact header of the SIP 302 response. The Diverting
number is mapped to the user part in the Diversion header of the SIP 302 response.