Parameter Description
Daylight Saving Time Parameters
Web: Day Light Saving
Time
EMS: Mode
CLI: summer-time
[DayLightSavingTimeEn
able]
Enables daylight saving time.
[0] Disable (default)
[1] Enable
Web: Start Time or Day of
Month Start
EMS: Start
CLI: start
[DayLightSavingTimeSt
art]
Defines the date and time when daylight saving begins. This value can
be configured using any of the following formats:
Day of year - mm:dd:hh:mm, where:
mm denotes minutes
For example, "05:01:08:00" denotes daylight saving starting from
May 1 at 8 A.M.
Day of month - mm:day/wk:hh:mm, where:
mm denotes minutes (e.g., 10)
For example, "04:FRI/03:23:00" denotes Friday, the third week of
April, at 11 P.M. The week field can be 1-5, where 5 denotes the last
occurrence of the specified day in the specified month. For example,
"04:FRI/05:23:00" denotes the last Friday of April, at 11 P.M.
Web: End Time or Day of
Month End
EMS: End
CLI: end
[DayLightSavingTimeEn
d]
Defines the date and time when daylight saving ends. For a description
of the format of this value, see the DayLightSavingTimeStart parameter.
Web/EMS: Offset
CLI: offset
[DayLightSavingTimeOff
set]
Defines the daylight saving time offset (in minutes).
The valid range is 0 to 120. The default is 60.
66.1.9 Power over Ethernet Parameters
The power-over-Ethernet (PoE) parameters are described in the table below.
PoE Parameters
Parameter Description
Web: Power over
Ethernet Settings
CLI: configure system >
interface poe-table
[POETable]
This table enables PoE (IEEE 802.3af-2003) per LAN port and
configures the maximum power consumption allowed per port for Class
0 clients connected to it.
[POETable]
FORMAT POETable_Index = POETable_PortEnable,