Note: For a detailed description of this table, see 'Configuring Cost
Groups' on page 199.
Web: Cost Group > Time
Band Table
EMS: Time Band
Provisioning > Time Band
CLI: configure voip >
services least-cost-routing
cost-group-time-bands
[CostGroupTimebands]
This table parameter configures time bands and associates them
with Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
Note: For a detailed description of this table, see 'Configuring Time
Bands for Cost Groups' on page 200.
66.13 LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below. For more information on routing based on LDAP, see 'Routing Based on LDAP
Active Directory Queries' on page 185.
LDAP Parameters
Parameter Description
Web: LDAP Service
CLI: enable
[LDAPServiceEnable]
Enables the LDAP feature.
[0] Disable (default)
[1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: LDAP Server IP
EMS: Server Ip
[LDAPServerIP]
Defines the LDAP server's address as an IP address (in dotted-
decimal notation, e.g., 192.10.1.255).
The default is 0.0.0.0.
Web: LDAP Server Port
EMS: Server Port
CLI: server-port
[LDAPServerPort]
Defines the LDAP server's port number.
The valid value range is 0 to 65535. The default port number is 389.
Web: LDAP Server
Domain Name
EMS: Server Domain
Name
CLI: server-domain-name
[LDAPServerDomainNam
e]
Defines the host name (FQDN) of the LDAP server. The device tries
to connect to the LDAP server according to the IP address list
received in the DNS query. If there is no connection to the LDAP
server or the connection to the LDAP server fails, the device tries to
connect to the LDAP server with the next IP address in the DNS
query list.
Note: The 'LDAP Server IP' parameter takes precedence over this
parameter. Thus, if you want to use an FQDN, keep the 'LDAP
Server IP' parameter empty.
Web: LDAP Password
EMS: Password
[LDAPPassword]
Defines the LDAP server's user password.
Web: LDAP Bind DN
EMS: Bind DN
Defines the LDAP server's bind Distinguished Name (DN). This is
used as the username during connection and binding to the server.
To Next Page
Loading...
