Security Parameter Index (SPI): A 32 bit value that together with an IP
address and a security protocol, uniquely identifies a particular security
association. The local and remote values must be coordinated with their
respective values on the IPSec peer.
Use Different Encryption Keys: Selecting this option allows you to
define both local and remote algorithm keys when defining the IPSec
protocol.
IPSec Protocol: Select between the ESP and AH IPSec protocols. The
page refreshes accordingly:
- ESP – Select the encryption and authentication algorithms, and enter
the algorithm keys in hexadecimal representation.
- AH – Select the hash algorithm, and enter the algorithm key in
hexadecimal representation.
12. Click OK to save the settings.
47.10 Internet Protocol Security Server (IPSec Server)
The below procedure describes how to create an IPSec server.
To create an IPSec server connection:
1. In the Connections page, click the New icon; the Connection Wizard opens.
2. Select the Connect to a Virtual Private Network over the Internet option, and then
click Next.
Figure 47-50: VPN Connection Type
3. Select the VPN Server option, and then click Next.
Figure 47-51: VPN Protocols
4. Select the Internet Protocol Security Server (IPSec Server) option, and then click
Next.
To Next Page
Loading...
