• Upload: Used by the ACS to cause the CPE to upload (to the ACS) the following
files to a designated location:
♦ Vendor Configuration File (File Type = 1 or 3): Output of show running-
config CLI command, which includes Data and Voice configuration. For
File Type 3 (where index is included – see below) only one instance of the
file is supported.
♦ Vendor Log File (File Type = 2 or 4): “Aggregated” log file. For File Type 2,
the last file is supported. For File Type 4 (where index is included – see
below), multiple files is supported.
The CPE responds to the Upload method, indicating successful or unsuccessful
completion via the UploadResponse or TransferComplete method.
For a complete description of the Upload method, refer to TR-069 Amendment 3
section A.4.1.5.
• Reboot: Reboots the CPE. The CPE sends the method response and completes
the remainder of the session prior to rebooting.
• X_0090F8_CommandResponse: Runs CLI commands.
ACS Methods:
• Inform: A CPE must call this method to initiate a transaction sequence whenever
a connection to an ACS is established.
• TransferComplete: Informs the ACS of the completion (either successful or
unsuccessful) of a file transfer initiated by an earlier Download or Upload method
call.
9.2 TR-104
The device supports TR-104 for configuration. This support is for the SIP (VoIP) application
layer and applies to FXS interfaces (lines) only. TR-104 defines a "data model" template for
TR-069 enabled devices. The "data model" that is applicable to the AudioCodes device is
defined in the DSL Forum TR-104 – "DSLHome™ Provisioning Parameters for VoIP CPE"
at http://www.broadband-forum.org/technical/download/TR-104.pdf.
The hierarchical tree structure of the supported TR-104 objects is shown below:
To Next Page
Loading...
