AudioCodes Media 800 MSBR

Version 6.6 781 Mediant 800 MSBR
User's Manual 66. Configuration Parameters Reference
Parameter Description
default of this parameter is changed to ‘RC4:EXP’, enabling RC-
128bit encryption.
 The value ‘ALL’ can be configured only if the “Strong Encryption”
Software License Key is enabled.
Web: HTTP
Authentication Mode
EMS: Web
Authentication Mode
CLI: http-auth-mode
[WebAuthMode]
Determines the authentication mode used for the Web interface.
 [0] Basic Mode = (Default) Basic authentication (clear text) is used.
 [1] Web Based Authentication = Digest authentication (MD5) is used.
Note: If you enable RADIUS login (i.e., the WebRADIUSLogin parameter
is set to 1), you must set the WebAuthMode parameter to Basic Mode
[0].
Web: Requires Client
Certificates for HTTPS
connection
CLI: req-client-cert
[HTTPSRequireClientC
ertificate]
Determines whether client certificates are required for HTTPS
connection.
 [0] Disable = (Default) Client certificates are not required.
 [1] Enable
= Client certificates are required. The client certificate must
be preloaded to the device and its matching private key must be
installed on the managing PC. Time and date must be correctly set on
the device for the client certificate to be verified.
Notes:
 For this parameter to take effect, a device reset is required.
 For a description on implementing client certificates, see 'Client
Certificates' on page 104.
66.4.3 SRTP Parameters
The Secure Real-Time Transport Protocol (SRTP) parameters are described in the table
below.
SRTP Parameters
Parameter Description
Web: Media Security
EMS: Enable Media
Security
CLI: media-security-
enable
[EnableMediaSecurity]
Enables Secure Real-Time Transport Protocol (SRTP).
 [0] Disable = (Default) SRTP is disabled.
 [1] Enable = SRTP is enabled.
Note: For this parameter to take effect, a device reset is required.
Web/EMS: Media
Security Behavior
[MediaSecurityBehavio
ur]
Determines the device's mode of operation when SRTP is used (i.e.,
when the parameter EnableMediaSecurity is set to 1).
 [0] Preferable = (Default) The device initiates encrypted calls.
However, if negotiation of the cipher suite fails, an unencrypted call is
established. Incoming calls that don't include encryption information
are accepted.
 [1] Mandatory = The device initiates encrypted calls, but if negotiation
of the cipher suite fails, the call is terminated. Incoming calls that don't
include encryption information are rejected.
 [2] Disable = The IP Profile for which this parameter is set does not
support encrypted calls (i.e., SRTP).
 [3] Preferable - Single Media = The device sends SDP with a single
media ('m=') line only (e.g., m=audio 6000 RTP/AVP 4 0 70 96) with
RTP/AVP and crypto keys. The remote UA can respond with SRTP or