Notes:
This parameter is only for testing incoming calls destined to this
prefix number.
This feature is applicable to all applications (GW/IP-to-IP and SBC).
Web: SBC Test ID
CLI: sbc-test-id
[SBCtestID]
Defines the SBC test call prefix (ID) for identifying SBC test calls that
traverse the device to register with an external routing entity such as
an IP PBX or proxy server.
This parameter functions together with the TestCallID parameter,
which defines the prefix of the simulated endpoint. Upon receiving an
incoming call with this prefix, the device removes the prefix, enabling it
to forward the test call to the external entity. Upon receiving the call
from the external entity, the device identifies the call as a test call
according to its prefix, defined by the TestCallID, and then sends the
call to the simulated endpoint.
For example, assume SBCTestID is set to 4 and TestCallID to 2. If a
call is received with called destination 4200, the device removes the
prefix 4 and routes the call to the IP PBX. When it receives the call
from the IP PBX, it identifies the call as a test call (i.e., prefix 2) and
therefore, sends it to the simulated endpoint.
The valid value can be any string of up to 15 characters. By default, no
number is defined.
Note: This feature is applicable only to the SBC application.
Test Call Table
Web: Test Call Table
CLI: configure system >
test-call > test-call-table
[Test_Call]
Defines the local and remote endpoints to be tested.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupID,
Test_Call_DestAddress, Test_Call_DestTransportType,
Test_Call_SRD, Test_Call_ApplicationType, Test_Call_AutoRegister,
Test_Call_UserName, Test_Call_Password, Test_Call_CallParty,
Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval;
[\Test_Call]
Note: For a description of this table, see 'Configuring Test Calls' on
page 737.
66.3.3 Syslog, CDR and Debug Parameters
The Syslog, CDR and debug parameters are described in the table below.
Syslog, CDR and Debug Parameters
Parameter Description
Web: Enable Syslog
EMS: Syslog enable
CLI: syslog
[EnableSyslog]
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.
[0] Disable (default)
[1] Enable
To Next Page
Loading...
