Version 6.6 53 Mediant 800 MSBR
User's Manual 5. Web-Based Management
5.1.6.3 Modifying and Saving Parameters
When you modify a parameter value on a page, the Edit symbol appears to the right of
the parameter. This indicates that the parameter has been modified, but has yet to be
applied (submitted). After you apply your modifications, the symbol disappears.
Figure 5-9: Edit Symbol after Modifying Parameter Value
To save configuration changes on a page to the device's volatile memory (RAM),
do one of the following:
On the toolbar, click the Submit button.
At the bottom of the page, click the Submit button.
When you click Submit, modifications to parameters with on-the-fly capabilities are
immediately applied to the device and take effect. Parameters displayed on the page with
the lightning symbol take effect only after a device reset. For resetting the device, see
'Resetting the Device' on page 621.
Note: Parameters saved to the volatile memory (by clicking Submit), revert to their
previous settings after a hardware or software reset, or if the device is
powered down. Therefore, to ensure parameter changes (whether on-the-fly
or not) are retained, save ('burn') them to the device's non-volatile memory,
i.e., flash (see 'Saving Configuration' on page 624).
If you enter an invalid parameter value (e.g., not in the range of permitted values) and then
click Submit, a message box appears notifying you of the invalid value. In addition, the
parameter value reverts to its previous value and is highlighted in red, as shown in the
figure below:
To Next Page
Loading...
