AudioCodes Media 800 MSBR

User's Manual 792 Document #: LTRT-12809
Mediant 800 MSBR
66.6 SIP Media Realm Parameters
The Media Realm parameters are described in the table below.
Media Realm Parameters
Parameter Description
Media Realm Table
Web: Media Realm Table
EMS: VoIP > Media >
Media Realm
CLI: configure voip >
media realm
[CpMediaRealm]
This table parameter defines the Media Realm table. The Media Realm
table allows you to divide a Media-type interface (defined in the Multiple
Interface table) into several realms, where each realm is specified by a
UDP port range.
The format of this parameter is as follows:
[CpMediaRealm]
FORMAT CpMediaRealm_Index = CpMediaRealm_MediaRealmName,
CpMediaRealm_IPv4IF, CpMediaRealm_IPv6IF,
CpMediaRealm_PortRangeStart, CpMediaRealm_MediaSessionLeg,
CpMediaRealm_PortRangeEnd, CpMediaRealm_TransRateRatio,
CpMediaRealm_IsDefault;
[\CpMediaRealm]
For example,
CpMediaRealm 1 = Mrealm1, Voice, , 6600, 20, 6790, , 1;
CpMediaRealm 2 = Mrealm2, Voice, , 6800, 10, 6890; , 0;
Notes:
 For this parameter to take effect, a device reset is required.
 For a detailed description of this table, see 'Configuring Media
Realms' on page 174.
Bandwidth Management per Media Realm Table
Web: Bandwidth
Management
[BWManagement]
This table parameter defines bandwidth management rules per Media
Realm.
The format of this parameter is as follows:
[ BWManagement ]
FORMAT BWManagement_Index =
BWManagement_MediaRealmIndex, BWManagement_ThresholdIndex,
BWManagement_RuleAction, BWManagement_Threshold,
BWManagement_Hysteresis;
[ \BWManagement ]
Where ThresholdIndex is the bandwidth threshold rule type:
 [0] High Threshold Rule
 [1] Critical Threshold Rule
Notes:
 For this parameter to take effect, a device reset is required.
 This table can include up to two row entries (where 0 is the first
index).
 For a detailed description of this table, see 'Configuring Bandwidth
Management per Media Realm' on page 179.
Quality of Experience Parameters
Web: Server IP
CLI: server-ip
[QOEServerIP]
Defines the IP address of AudioCodes Session Experience Manager
(SEM) server to where the quality experience reports are sent.
Note: For this parameter to take effect, a device reset is required.