29.9 Configuring Caller ID Permissions
The Caller ID Permissions table allows you to enable per port, Caller ID generation for FXS
interfaces and Caller ID detection for FXO interfaces.
Notes:
• If Caller ID permissions is not configured for a port in this table, its Caller
ID generation / detection is determined according to the global
parameter, 'Enable Call ID' in the Supplementary Services page
(Configuration tab > VoIP menu > GW and IP to IP > DTMF and
Supplementary > Supplementary Services).
• The Caller ID Permissions table can also be configured using the table
ini file parameter, EnableCallerID or the CLI command, configure voip >
gw analoggw enable-caller-id.
To configure Caller ID permissions per port:
1. Open the Caller ID Permissions page (Configuration tab > VoIP menu > GW and IP
to IP > Analog Gateway > Caller ID Permissions).
Figure 29-9: Caller ID Permissions Page
2. Configure the table as required. For a description of the parameter, see the table
below.
3. Click Submit to apply your changes.
Caller ID Permissions Table Parameter Description
Parameter Description
Caller ID
CLI: caller-id
[EnableCallerId_IsEnabl
ed]
Enables Caller ID generation (FXS) or detection (FXO) per port.
[0] Disable
[1] Enable
To Next Page
Loading...
