To configure Call Forward per port:
1. Open the Call Forward Table page (Configuration tab > VoIP menu > GW and IP to
IP > Analog Gateway > Call Forward).
Figure 29-8: Call Forward Table Page
2. Configure the table as required. For descriptions of the parameters, see the table
below.
3. Click Submit to apply your changes.
Call Forward Table Parameter Description
Parameter Description
Forward Type
CLI: type
[FwdInfo_Type]
Defines the condition upon which the call is forwarded.
[0] Deactivate = (Default) Don't forward incoming calls.
[1] On Busy = Forward incoming calls when the port is busy.
[2] Unconditional = Always forward incoming calls.
[3] No Answer = Forward incoming calls that are not answered
within the time specified in the 'Time for No Reply Forward' field.
[4] On Busy or No Answer = Forward incoming calls when the port
is busy or when calls are not answered within the time specified in
the 'Time for No Reply Forward' field.
[5] Do Not Disturb = Immediately reject incoming calls.
Forward to Phone
Number
CLI: destination
[FwdInfo_Destination]
Defines the telephone number or URI (<number>@<IP address>) to
where the call is forwarded.
Note: If this parameter is configured with only a telephone number and
a Proxy isn't used, this forwarded-to phone number must be specified
in the Outbound IP Routing Table (see 'Configuring Outbound IP
Routing Table' on page 327).
Time for No Reply
Forward
CLI: no-reply-time
[FwdInfo_NoReplyTime]
If you have set the 'Forward Type' for this port to No Answer, then
configure the number of seconds the device waits before forwarding
the call to the specified phone number.
To Next Page
Loading...
