AudioCodes Media 800 MSBR

Version 6.6 835 Mediant 800 MSBR
User's Manual 66. Configuration Parameters Reference
Parameter Description
Message Policy Table
Web: Message Policy
Table
CLI: configure voip > sbc
message-policy
[MessagePolicy]
This table parameter configures SIP message policy rules for blocking
(blacklist) unwanted incoming SIP messages or allowing (whitelist)
receipt of desired messages.The format of this parameter is as follows:
[MessagePolicy]
FORMAT MessagePolicy_Index = MessagePolicy_Policy,
MessagePolicy_MaxMessageLength,
MessagePolicy_MaxHeaderLength, MessagePoliy_MaxBodyLength,
MessagePolicy_MaxNumHeaders, MessagePolicy_MaxNumBodies,
MessagePolicy_SendRejection, MessagePolicy_MethodListType,
MessagePolicy_MethodList, MessagePolicy_BodyListType,
MessagePolicy_BodyList;
[/MessagePolicy]
Note: For a detailed description of this table, see 'Configuring SIP
Message Policy Rules'.
66.9 Coders and Profile Parameters
The profile parameters are described in the table below.
Profile Parameters
Parameter Description
Coders Table / Coder Groups Table
Web: Coders
Table/Coder Group
Settings
EMS: Coders Group
CLI: configure voip >
coders-and-profiles
coders-group
[CodersGroup0]
[CodersGroup1]
[CodersGroup2]
[CodersGroup3]
[CodersGroup4]
[CodersGroup5]
[CodersGroup6]
[CodersGroup7]
[CodersGroup8]
[CodersGroup9]
This table parameter defines the device's coders. Each group
can consist of up to 10 coders. The first Coder Group is the
default coder list and the default Coder Group.
The format of this parameter is as follows:
[ CodersGroup<0-9> ]
FORMAT CodersGroup0_Index = CodersGroup0_Name,
CodersGroup0_pTime, CodersGroup0_rate,
CodersGroup0_PayloadType, CodersGroup0_Sce;
[ \CodersGroup<0-9 ]
For example, below are defined two Coder Groups (0 and 1):
[ CodersGroup0 ]
FORMAT CodersGroup0_Index = CodersGroup0_Name,
CodersGroup0_pTime, CodersGroup0_rate,
CodersGroup0_PayloadType, CodersGroup0_Sce;
CodersGroup0 0 = g711Alaw64k, 20, 0, 255, 0;
CodersGroup0 1 = eg711Ulaw, 10, 0, 71, 0;
CodersGroup0 2 = eg711Ulaw, 10, 0, 71, 0;
[ \CodersGroup0 ]
[ CodersGroup1 ]
FORMAT CodersGroup1_Index = CodersGroup1_Name,
CodersGroup1_pTime, CodersGroup1_rate,
CodersGroup1_PayloadType, CodersGroup1_Sce;
CodersGroup1 0 = Transparent, 20, 0, 56, 0;
CodersGroup1 1 = g726, 20, 0, 23, 0;
[ \CodersGroup1 ]