Parameter Description
Phone Context Table
Web: Phone Context Table
EMS: SIP Manipulations >
Phone Context
CLI: configure voip > gw
manipulations phone-
context-table
[PhoneContext]
This table parameter configures the Phone Context table. This
parameter maps NPI and TON to the SIP 'phone-context' parameter,
and vice versa.
The format for this parameter is as follows:
[PhoneContext]
FORMAT PhoneContext_Index = PhoneContext_Npi,
PhoneContext_Ton, PhoneContext_Context;
[\PhoneContext]
For example:
PhoneContext 0 = 0,0,unknown.com
PhoneContext 1 = 1,1,host.com
PhoneContext 2 = 9,1,na.e164.host.com
Note: For a detailed description of this table, see 'Mapping NPI/TON to
SIP Phone-Context' on page 317.
Web/EMS: Add Phone
Context As Prefix
CLI: add-ph-cntxt-as-pref
[AddPhoneContextAsPrefi
x]
Determines whether the received Phone-Context parameter is added as
a prefix to the outgoing ISDN Setup message with (for digital interfaces)
Called and Calling numbers.
[0] Disable (default)
[1] Enable
66.12 Least Cost Routing Parameters
The Least Cost Routing (LCR) parameters are described in the table below.
LCR Parameters
Parameter Description
Web: Routing Rule Groups
Table
CLI: configure voip >
services least-cost-routing
routing-rule-groups
[RoutingRuleGroups]
This table parameter enables the LCR feature and configures the
average call duration and default call cost. The default call cost
determines whether routing rules that are not configured with a Cost
Group are considered as a higher or lower cost route compared to
other matching routing rules that are assigned Cost Groups.
[ RoutingRuleGroups ]
FORMAT RoutingRuleGroups_Index =
RoutingRuleGroups_LCREnable,
RoutingRuleGroups_LCRAverageCallLength,
RoutingRuleGroups_LCRDefaultCost;
[ \RoutingRuleGroups ]
Note: For a detailed description of this table, see 'Enabling LCR and
Configuring Default LCR' on page 197.
Web: Cost Group Table
EMS: Cost Group
Provisioning > Cost Group
CLI: configure voip >
services least-cost-routing
cost-group
[CostGroupTable]
This table parameter configures the Cost Groups for LCR, where
each Cost Group is configured with a name, fixed call connection
charge, and a call rate (charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
To Next Page
Loading...
