Parameter Description
CLI: cas-delimiters-types
[CASDelimitersPaddingUsag
e]
Defines the digits string delimiter padding usage per trunk.
[0] = (Default) Default address string padding: '*XXX#' (where
XXX is the digit string that begins with '*' and ends with '#',
when using padding).
[1] = Special use of asterisks delimiters: '*XXX*YYY*' (where
XXX is the address, YYY is the source phone number, and '*'
is the only delimiter padding).
Note: For this parameter to take effect, a device reset is required.
Web: CAS Table per Trunk
EMS: Trunk CAS Table Index
CLI: cas-table-index
[CASTableIndex_x]
Defines the CAS protocol per trunk from a list of CAS protocols
defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1 to
use the E&M Winkstart CAS (E_M_WinkTable.dat) protocol, and
Trunks 2 and 3 to use the E&M Immediate Start CAS
(E_M_ImmediateTable.dat) protocol:
CASFileName_0 = 'E_M_WinkTable.dat'
CASFileName_1 = 'E_M_ImmediateTable.dat'
CASTableIndex_0 = 0
CASTableIndex_1 = 0
CASTableIndex_2 = 1
CASTableIndex_3 = 1
Notes:
You can define CAS tables per B-channel using the parameter
CASChannelIndex.
The x in the ini file parameter denotes the trunk number,
where 0 is Trunk 1.
Web: Dial Plan
EMS: Dial Plan Name
CLI: cas-dial-plan-name
[CASTrunkDialPlanName_x]
Defines the CAS Dial Plan name per trunk.
The range is up to 11 characters.
For example, the below configures E1_MFCR2 trunk with a single
protocol (Trunk 5):
ProtocolType_5 = 7
CASFileName_0='R2_Korea_CP_ANI.dat'
CASTableIndex_5 = 0
DialPlanFileName = 'DialPlan_USA.dat'
CASTrunkDialPlanName_5 = 'AT_T'
Note: The x in the ini file parameter denotes the trunk number,
where 0 is Trunk 1.
[CASFileName_x]
Defines the CAS file name (e.g., 'E_M_WinkTable.dat') that
defines the CAS protocol, where x denotes the CAS file ID (0-7).
It is possible to define up to eight different CAS files by repeating
this parameter. Each CAS file can be associated with one or more
of the device's trunks, using the parameter CASTableIndex_x.
Note: For this parameter to take effect, a device reset is required.
Web/EMS: CAS Table per
Channel
CLI: cas-channel-index
[CASChannelIndex]
Defines the loaded CAS protocol table index per B-channel
pertaining to a CAS trunk. This parameter is assigned a string
value and can be set in one of the following two formats:
CAS table per channel: Each channel is separated by a
comma and the value entered denotes the CAS table index
used for that channel. The syntax is <CAS index>,<CAS
index> (e.g., "1,2,1,2…"). For this format, 31 indices must be
defined for E1 trunks (including dummy for B-channel 16), or
To Next Page
Loading...
