AudioCodes Media 800 MSBR

Version 6.6 237 Mediant 800 MSBR
User's Manual 20. SIP Definitions
Note: The Me
ssage Policy table can also be configured using the table ini file
parameter, MessagePolicy
or the CLI command, configure voip > sbc
message-policy.
 To configure SIP message policy rules:
1. Open the Message Policy Table page (Configuration tab > VoIP menu > SIP
Definitions > Msg Policy & Manipulation > Message Policy Table).
2. Click the Add button; the Add Record dialog box appears:
Figure 20-5: Message Policy Table - Add Record Dialog Box
The policy defined above limits SIP messages to 32,768 characters, headers to 256
characters, bodies to 512 characters, number of headers to 16, and only permits two
bodies. Invalid requests are rejected. Only INVITE and BYE requests are permitted
and there are no restrictions on bodies.
3. Configure the SIP message policy rule as required. See the table below for a
description of each parameter.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 624.
SIP Message Policy Parameters
Parameter Description
Index
[MessagePolicy_Index]
Defines the table index entry.
Max Message Length
CLI: max-message-
length
[MessagePolicy_MaxM
essageLength]
Defines the maximum SIP message length.
The valid value is up to 32,768 characters. The default is 32,768.
Max Header Length
CLI: max-header-length
[MessagePolicy_MaxH
eaderLength]
Defines the maximum SIP header length.
The valid value is up to 512 characters. The default is 512.