AudioCodes Media 800 MSBR

Version 6.6 265 Mediant 800 MSBR
User's Manual 22. IP-to-IP Routing Overview
Figure 22-5: SIP Trunking Setup Scenario Example
The steps for configuring the device according to the scenario above can be summarized
as follows:

Enable the IP-to-IP feature (see 'Step 1: Enable the IP-to-IP Capabilities' on page
266).

Configure the number of media channels (see 'Step 2: Configure the Number of Media
Channels' on page
266).

Configure a Trunk Group for interfacing with the local PSTN (see 'Step 3: Define a
Trunk Group for the Local PSTN' on page
266).

Configure Proxy Sets (see 'Step 4: Configure the Proxy Sets' on page 267).

Configure IP Groups (see 'Step 5: Configure the IP Groups' on page 269).

Configure Registration Accounts (see 'Step 6: Configure the Account Table' on page
270).

Configure IP Profiles (see 'Step 7: Configure IP Profiles for Voice Coders' on page
271).

Configure inbound IP routing rules (see 'Step 8: Configure Inbound IP Routing' on
page
272).

Configure outbound IP routing rules (see 'Step 9: Configure Outbound IP Routing' on
page
274).

Configure destination phone number manipulation (see 'Step 10: Configure
Destination Phone Number Manipulation' on page
275).