10. At the prompt, type the following command to set the prefix length, and then press
Enter:
(network-if-0)# set prefix-length <prefix length, e.g., 16>
11. At the prompt, type the following command to set the Default Gateway, and then press
Enter:
(network-if-0)# set gateway <IP address>
12. At the prompt, type the following command to exit the Multiple Interface table, and
then press Enter:
(network-if-0)# exit
13. At the prompt, type the following command to exit the VoIP interface, and then press
Enter:
(config-voip)# exit
14. At the prompt, type the following command to save your changes and to reset the
device, and then press Enter:
# reload
To Next Page
Loading...
