AudioCodes Media 800 MSBR

Version 6.6 283 Mediant 800 MSBR
User's Manual 23. Digital PSTN
• The modification of the CAS state machine occurs at the CAS application
initialization only for non-default values (-1).
• For more information on the CAS Protocol table, refer to the CAS
Protocol Table Configuration Note.
CAS State Machine Parameters Description
Parameter Description
Generate Digit On Time
[CasStateMachineGenerate
DigitOnTime]
Generates digit on-time (in msec).
The value must be a positive value. The default is -1 (use value
from CAS state machine).
Generate Inter Digit Time
[CasStateMachineGenerateI
nterDigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default is -1 (use value
from CAS state machine).
DTMF Max Detection Time
[CasStateMachineDTMFMa
xOnDetectionTime]
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default is -1 (use value
from CAS state machine).
DTMF Min Detection Time
[CasStateMachineDTMFMin
OnDetectionTime]
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may be
used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default is -1 (use value
from CAS state machine).
MAX Incoming Address Digits
[CasStateMachineMaxNum
OfIncomingAddressDigits]
Defines the limitation for the maximum address digits that need to
be collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default is -1 (use value from
CAS state machine).
MAX Incoming ANI Digits
[CasStateMachineMaxNum
OfIncomingANIDigits]
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of ANI
digits is stopped.
The value must be an integer. The default is -1 (use value from
CAS state machine).
Collet ANI
[CasStateMachineCollectA
NI]
In some cases, when the state machine handles the ANI collection
(not related to MFCR2), you can cont
rol the state machine to collect
ANI or discard ANI.
 [0] No = Don't collect ANI.
 [1] Yes = Collect ANI.
 [-1] Default = Default value - use value from CAS state machine.
Digit Signaling System
[CasStateMachineDigitSign
alingSystem]
Defines which Signaling System to use in both directions
(detection\generation).
 [0] DTMF = Uses DTMF signaling.
 [1] MF = Uses MF signaling (default).
 [-1] Default = Default value - use value from CAS state machine.