AudioCodes Media 800 MSBR

Version 6.6 301 Mediant 800 MSBR
User's Manual 24. Trunk Group
Parameter Description
Trunk Group Name
CLI: trunk-group-name
[TrunkGroupSettings_Tr
unkGroupName]
Defines a name for the Trunk Group. This name represents the
Trunk Group in the SIP 'tgrp' parameter of the outgoing INVITE
messages (according to RFC 4904). For example:
sip:+16305550100;tgrp=TG-1;trunk-context=+1-
630@isp.example.net;user=phone
The valid value can be a string of up to 20 characters. By default, no
name is configured.
Notes:
 If this parameter is not configured, the Trunk Group decimal
number is used in the SIP 'tgrp' parameter.
 This feature is enabled by any of the following parameters:

UseSIPtgrp

UseBroadsoftDTG
 Currently, this parameter can only be configured using the ini file.
MWI Interrogation Type
CLI: mwi-interrogation-type
[TrunkGroupSettings_M
WIInterrogationType]
Defines MWI QSIG-to-IP interworking for interrogating MWI
supplementary services:
 [255] Not Configured
 [0] None = Disables the feature.
 [1] Use Activate Only = MWI Interrogation messages are not sent
and only "passively" responds to MWI Activate requests from the
PBX.
 [2] Result Not Used = MWI Interrogation messages are sent, but
the result is not used. Instead, the device waits for MWI Activate
requests from the PBX.
 [3] Use Result = MWI Interrogation messages are sent, its results
are used, and the MWI Activate requests are used. MWI Activate
r
equests are interworked to SIP NOTIFY MWI messages. The SIP
NOTIFY messages are sent to the IP Group defined by the
NotificationIPGroupID parameter.
Note: This parameter appears in the table only if the
VoiceMailInterface parameter is set to 3 (QSIG). Configuring Voice
Mail on page 395.