AudioCodes Media 800 MSBR - Page 331

Version 6.6 331 Mediant 800 MSBR
User's Manual 26. Routing
Example of Tel-to-IP Source Phone Number Manipulation Rules
Parameter Rule
1
Rule 2 Rule 3 Rule 4 Rule 5 Rule 6 Rule 7 Rule 8 Rule 9
Src. IP
Group ID
- - - - - 2 - - -
Src.
Trunk
Group ID
* 0 1 - - - - - -
Src. Host
Prefix
- - - - - domain.c
om
- - -
Src.
Trunk
Group ID
- - * 1 - - * * *
Dest.
Phone
Prefix
10 10 20 [5,7-9] 00 * 100 100 100
Source
Phone
Prefix
100 100 * * * * * * *
Dest. IP
Address
10.33
.45.6
3
10.33.45.
50
- domain.c
om
0.0.0.0 10.33.45.
65
10.33.45.
68
10.33.45.
67
domain.c
om
Dest IP
Group ID
- - 1 - - - - - -
IP Profile
ID
1 1 - - - - - - -
Cost
Group ID
Week
end
Weekend
_B
- - - - - - -
Forking
Group
- - - - 1 2 1
Tel-to-IP / Outbound IP Routing Table Parameters
Parameter Description
Matching Call Characteristics
Web/EMS: Tel to IP
Routing Mode
CLI: configure voip >
gw routing general-
setting > tel2ip-rte-
mode
[RouteModeTel2IP]
Determines whether to route received calls to an IP destination before or
after manipulation of the destination number.
 [0] Route calls before manipulation = Calls are routed before the number
manipulation rules are applied (default).
 [1] Route calls after manipulation = Calls are routed after the number
manipulation rules are applied.
Notes:
 This parameter is not applicable if outbound proxy routing is used.
 For number manipulation, see 'Configuring Source/Destination Number
Manipulation' on page 303.