AudioCodes Media 800 MSBR

Version 6.6 393 Mediant 800 MSBR
User's Manual 28. Configuring Supplementary Services
2. Configure the parameters as described in the table below.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 624.
5. To register the BRI endpoints, click the Register button. To unregister the BRI
endpoints, click Unregister. The registration method for each BRI endpoint is
according to the setting of the 'Registration Mode' parameter in the Trunk Group
Settings page.
ISDN Supp Services Table Parameters
Parameter Description
Phone Number
CLI: phone-number
[ISDNSuppServ_PhoneNu
mber]
Defines the telephone extension number for the BRI endpoint.
Module
CLI: module
[ISDNSuppServ_Module]
Defines the BRI module number to which the BRI extension pertains.
Port
CLI: port
[ISDNSuppServ_Port]
Defines the port number on the BRI module to which the BRI
extension is connected.
User ID
CLI: user-id
[ISDNSuppServ_UserId]
Defines the User ID for registering the BRI endpoint to a third-party
softswitch for authentication and/or billing.
User Password
CLI: user-password
[ISDNSuppServ_UserPass
word]
Defines the user password for registering the BRI endpoint to a third-
party softswitch for authentication and/or billing.
Note: For security, the password is displayed as an asterisk (*).
Caller ID Number
CLI: caller-id-number
[ISDNSuppServ_CallerID]
Defines the caller ID name of the BRI extension (sent to the IP side).
The valid value is a string of up to 18 characters.
Presentation Restricted
CLI: presentation-restricted
[ISDNSuppServ_IsPresent
ationRestricted]
Determines whether the BRI extension sends its Caller ID
information to the IP when a call is made.
 [0] Allowed = The device sends the string defined in the 'Caller
ID' field when this BRI extension makes a Tel-to-IP call.
 [1] Restricted = The string defined in the 'Caller ID' field is not
sent.
Caller ID Enabled
CLI: caller-id-enable
[ISDNSuppServ_IsCallerID
Enabled]
Enables the receipt of Caller ID.
 [0] Disabled = The device does not send Caller ID information to
the BRI extension.
 [1] Enabled = The device sends Caller ID information to the BRI
extension