[1] Yes = If the above row entry rule matched the call, consider this
row entry as a match as well and perform the manipulation specified
by this rule.
Note: Additional manipulation can only be done on a different SIP URI,
source or destination, to the rule configured in the row above as
configured by the 'Manipulated URI' parameter (see below).
Manipulation Purpose
CLI: purpose
[IPInboundManipulatio
n_ManipulationPurpos
e]
Defines the purpose of the manipulation:
[0] Normal = (Default) Inbound manipulations affect the routing input
and source and/or destination number.
[1] Routing input only = Inbound manipulations affect the routing input
only, retaining the original source and destination number.
[2] Shared Line = Used for the Shared-Line Appearance feature. This
manipulation is for registration requests to change the destination
number of the secondary extension numbers to the primary
extension. For more information, see 'BroadSoft's Shared Phone Line
Call Appearance for SBC Survivability' on page 450.
Source IP Group ID
CLI: src-ip-group-id
[IPInboundManipulatio
n_SrcIpGroup]
Defines the IP Group from where the incoming INVITE is received.
For any IP Group, enter the value "-1".
Source Username Prefix
CLI: src-user-name-
prefix
[IPInboundManipulatio
n_SrcUsernamePrefix]
Defines the prefix of the source SIP URI user name (usually in the From
header).
For any prefix, enter the asterisk "*" symbol (default).
Note: The prefix can be a single digit or a range of digits. For available
notations, see 'Dialing Plan Notation for Routing and Manipulation' on
page 753.
Source Host
CLI: src-host
[IPInboundManipulatio
n_SrcHost]
Defines the source SIP URI host name - full name (usually in the From
header). For any host name, enter the asterisk "*" symbol (default).
Destination Username
Prefix
CLI: dst-user-name-
prefix
[IPInboundManipulatio
n_DestUsernamePrefix
]
Defines the prefix of the destination SIP URI user name (usually in the
Request-URI).
For any prefix, enter the asterisk "*" symbol (default).
Note: The prefix can be a single digit or a range of digits. For available
notations, see 'Dialing Plan Notation for Routing and Manipulation' on
page 753.
Destination Host
CLI: dst-host
[IPInboundManipulatio
n_DestHost]
Defines the destination SIP URI host name - full name (usually in the
Request URI).
For any host name, enter the asterisk "*" symbol (default).
Request Type
CLI: request-type
[IPInboundManipulatio
n_RequestType]
Defines the SIP request type to which the manipulation rule is applied.
[0] All = (Default) All SIP messages.
[1] INVITE = All SIP messages except REGISTER and SUBSCRIBE.
[2] REGISTER = Only REGISTER messages.
[3] SUBSCRIBE = Only SUBSCRIBE messages.
[4] INVITE and REGISTER = All SIP messages except SUBSCRIBE.
[5] INVITE and SUBSCRIBE = All SIP messages except REGISTER.
To Next Page
Loading...
