Notes:
• Manipulated destination SIP URI user names are done on the following
SIP headers: Request URI, To, and Remote-Party-ID (if exists).
• Manipulated source SIP URI user names are done on the following SIP
headers: From, P-Asserted (if exists), P-Preferred (if exists), and
Remote-Party-ID (if exists)
• SIP URI host name (source and destination) manipulations can also be
configured in the IP Group table. These manipulations are simply host
name substitutions with the names defined for the source and destination
IP Groups respectively.
• The IP to IP Outbound Manipulation table can also be configured using
the table ini file parameter, IPOutboundManipulation or CLI command,
configure voip > sbc manipulations ip-outbound-manipulation.
To configure IP-to-IP outbound manipulation rules:
1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP to IP Outbound).
2. Click the Add button; the following dialog box appears:
Figure 31-13: IP to IP Outbound Manipulation Page - Add Dialog Box
3. Configure a rule as required. For a description of the parameters, see the table below.
4. Click Submit.
IP to IP Outbound Manipulation Table Parameters Description
Parameter Description
Matching Characteristics (Rule)
Additional Manipulation
CLI: is-additional-
Determines whether additional SIP URI user part manipulation is done
for the table entry rule listed directly above it.
To Next Page
Loading...
