Figure 35-9: Add Record Dialog Box of SAS IP2IP Routing Page
3. Configure the rule according to the table below.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 624.
Note: The following parameters are not applicable to SAS and must be ignored:
• 'Source IP Group ID'
• 'Destination IP Group ID'
• 'Destination SRD ID'
• 'Alternative Route Options'
SAS IP-to-IP Routing Table Parameters
Parameter Description
Matching Characteristics
Source IP Group ID
[IP2IPRouting_SrcIPGro
upID]
CLI: src-ip-group-id
Selects the IP Group from where the IP-to-IP call originated. Typically,
the IP Group of an incoming SIP dialog is determined (or classified)
using the ‘Classification’ table (see Configuring Classification Rules on
page 462). If not used (i.e., any IP Group), simply leave the field empty.
The default is -1.
Source Username Prefix
[IP2IPRouting_SrcUser
namePrefix]
Defines the prefix of the user part of the incoming SIP dialog's source
URI (usually the From URI). You can use special notations for denoting
the prefix. For example, to denote any prefix, use the asterisk (*) symbol;
To Next Page
Loading...
