To set up and activate Zero Configuration:
1. Configure the HTTPS Redirect server with the following:
• MAC addresses of the devices you want to provision.
• Redirect URL of the provisioning server where the configuration file with the
Automatic Update settings is located.
• Name of the configuration file.
2. Establish a CLI session with the device and configure Zero Configuration:
a. Enable Zero Configuration (default), by running the following command:
# configure system
(config-system># automatic-update
(automatic-update)# set zero-conf <on|off>
b. Configure the URL of AudioCodes HTTPS Redirect server, by running the
following command:
(automatic-update)# set zero-conf-server <URL>
The default URL is https://redirect.audiocodes.com/<MAC address>.
3. Create a CLI-based configuration file with settings relating to the Automatic Update
feature (see 'Configuring Automatic Update' on page 656) and place it on the HTTP/S
redirected provisioning server.
4. Place the configuration, software (cmp), and/or auxiliary files on a provisioning server.
This server can be the same provisioning server or any other server(s).
5. Configure the device's WAN interface and cable the device to the WAN network.
6. Power down and then power up the device.
To Next Page
Loading...
