Parameter Description
Account Table
Web: Account Table
EMS: SIP Endpoints >
Account
CLI: configure voip > sip-
definition account
[Account]
This table parameter configures the Account table for registering and/or
authenticating (digest) Trunk Groups or IP Groups (e.g., an IP-PBX) to
another Serving IP Group (e.g., an Internet Telephony Service Provider
- ITSP). The format of this parameter is as follows:
[Account]
FORMAT Account_Index = Account_ServedTrunkGroup,
Account_ServedIPGroup, Account_ServingIPGroup,
Account_Username, Account_Password, Account_HostName,
Account_Register, Account_ContactUser, Account_ApplicationType;
[\Account]
For example:
Account 1 = 1, -1, 1, user, 1234, acl, 1, ITSP1, 0;
Note: For a detailed description of this table, see 'Configuring Account
Table' on page 225.
Proxy Registration Parameters
Web: Use Default Proxy
EMS: Proxy Used
CLI: enable-proxy
[IsProxyUsed]
Enables the use of a SIP proxy server.
[0] No = (Default) Proxy isn't used and instead, the internal routing
table is used.
[1] Yes = Proxy server is used. Define the IP address of the proxy
server in the Proxy Sets table (see 'Configuring Proxy Sets Table' on
page 219).
Notes:
If you are not using a proxy server, you must define outbound IP call
routing rules in the Outbound IP Routing Table (described in
Configuring Outbound IP Routing Table on page 327).
This parameter is applicable only to the GW/IP-to-IP application.
Web/EMS: Proxy Name
CLI: proxy-name
[ProxyName]
Defines the Home Proxy domain name. If specified, this name is used
as the Request-URI in REGISTER, INVITE and other SIP messages,
and as the host part of the To header in INVITE messages. If not
specified, the Proxy IP address is used instead.
The valid value is a string of up to 49 characters.
Note: This parameter functions together with the UseProxyIPasHost
parameter.
Web: Use Proxy IP as
Host
CLI: use-proxy-ip-as-host
[UseProxyIPasHost]
Enables the use of the proxy server's IP address (in dotted-decimal
notation) as the host name in SIP From and To headers in REGISTER
requests.
[0] Disable (default)
[1] Enable
If this parameter is disabled and the device registers to an IP Group
(i.e., proxy server), it uses the string configured by the ProxyName
parameter as the host name in the REGISTER's Request-URI and uses
the string configured by the IP Group table parameter, SIPGroupName
as the host name in the To and From headers. If the IP Group is
configured with a Proxy Set that has multiple IP addresses, all the
REGISTER messages sent to these proxies are sent with the same
host name.
Note: If this parameter is disabled and the ProxyName parameter is not
configured, the proxy's IP address is used as the host name in the
REGISTER Request-URI.
To Next Page
Loading...
