AudioCodes Media 800 MSBR - Page 800

User's Manual 800 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
balancing and redundancy mechanisms (if a Proxy Set contains more
than one proxy address).
The format of this parameter is as follows:
[ProxySet]
FORMAT ProxySet_Index = ProxySet_EnableProxyKeepAlive,
ProxySet_ProxyKeepAliveTime, ProxySet_ProxyLoadBalancingMethod,
ProxySet_IsProxyHotSwap, ProxySet_SRD,
ProxySet_ClassificationInput, ProxySet_ProxyRedundancyMode;
[\ProxySet]
For example:
ProxySet 0 = 0, 60, 0, 0, 0, , 1;
ProxySet 1 = 1, 60, 1, 0, 1, , 0;
Notes:
 For configuring the Proxy Set IDs and their IP addresses, use the
parameter ProxyIP.
 For a description of this table, see 'Configuring Proxy Sets Table' on
page 219.
Registrar Parameters
Web: Enable Registration
EMS: Is Register Needed
CLI: enable-registration
[IsRegisterNeeded]
Enables the device to register to a Proxy/Registrar server.
 [0] Disable = (Default) The device doesn't register to Proxy/Registrar
server.
 [1] Enable = The device registers to Proxy/Registrar server when the
device is powered up and at every user-defined interval (configured
by the parameter RegistrationTime).
Notes:
 This parameter is applicable only to the Gateway / IP-to-IP
application.
 The device sends a REGISTER request for each channel or for the
entire device (according to the AuthenticationMode parameter).
Web/EMS: Registrar
Name
CLI: registrar-name
[RegistrarName]
Defines the Registrar domain name. If specified, the name is used as
the Request-URI in REGISTER messages. If it isn't specified (default),
the Registrar IP address, or Proxy name or IP address is used instead.
The valid range is up to 100 characters.
Note: This parameter is applicable only to the Gateway / IP-to-IP
application.
Web: Registrar IP
Address
EMS: Registrar IP
CLI: ip-addrr-rgstrr
[RegistrarIP]
Defines the IP address (or FQDN) and port number (optional) of the
Registrar server. The IP address is in dotted-decimal notation, e.g.,
201.10.8.1:<5080>.
Notes:
 This parameter is applicable only to the Gateway / IP-to-IP
application.
 If not specified, the REGISTER request is sent to the primary Proxy
server.
 When a port number is specified, DNS NAPTR/SRV queries aren't
performed, even if the parameter DNSQueryType is set to 1 or 2.
 If the parameter RegistrarIP is set to an FQDN and is resolved to
multiple addresses, the device also provides real-time switching
(hotswap mode) between different Registrar IP addresses (the
parameter IsProxyHotSwap is set to 1). If the first Registrar doesn't
respond to the REGISTER message, the same REGISTER message
is sent immediately to the next Proxy. To allow this mechanism, the