AudioCodes Media 800 MSBR

Version 6.6 849 Mediant 800 MSBR
User's Manual 66. Configuration Parameters Reference
Parameter Description
CLI: V21-modem-transport-
type
[V21ModemTransportType]

[3] Events Only = Transparent with Events
Note: This parameter can also be configured in an IP Profile.
Web: V.22 Modem Transport
Type
EMS: V22 Transport
CLI: V22-modem-transport-
type
[V22ModemTransportType]
Determines the V.22 modem transport type.
 [0] Disable = Disable (Transparent)
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured in an IP Profile.
Web: V.23 Modem Transport
Type
EMS: V23 Transport
CLI: V23-modem-transport-
type
[V23ModemTransportType]
Determines the V.23 modem transport type.
 [0] Disable = Disable (Transparent)
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured in an IP Profile.
Web: V.32 Modem Transport
Type
EMS: V32 Transport
CLI: V32-modem-transport-
type
[V32ModemTransportType]
Determines the V.32 modem transport type.
 [0] Disable = Disable (Transparent)
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events
Notes:
 This parameter applies only to V.32 and V.32bis modems.
 This parameter can also be configured in an IP Profile.
Web: V.34 Modem Transport
Type
EMS: V34 Transport
CLI: V34-modem-transport-
type
[V34ModemTransportType]
Determines the V.90/V.34 modem transport type.
 [0] Disable = Disable (Transparent)
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured in an IP Profile.
EMS: Bell Transport Type
CLI: bell-modem-transport-type
[BellModemTransportType]
Determines the Bell modem transport method.
 [0] = Transparent (default)
 [2] = Bypass
 [3] = Transparent with events
Web/EMS: Fax CNG Mode
CLI: fax_cng_mode
[FaxCNGMode]
Determines the device's handling of fax relay upon detection of a
fax CNG tone or a V.34/Super G3 V8-CM (Call Menu) signal from
originating faxes.
 [0] Doesn't send T.38 Re-INVITE = (Default) SIP re-INVITE is
not sent.
 [1] Sends on CNG tone = Sends a SIP re-INVITE with T.38
parameters in SDP to the terminating fax upon detection of a
fax CNG tone, if the CNGDetectorMode parameter is set to 1.
 [2] Sends on CNG or v8-cn = Sends a SIP re-INVITE with T.38
parameters in SDP to the terminating fax upon detection of a
fax CNG tone (if the CNGDetectorMode parameter is set to 1)
or upon detection of a V8-CM signal.
Notes:
 If this parameter is set to [2] and the CNGDetectorMode
parameter is set to [0], the device sends a re-INVITE only if it
detects a V8-CM signal from the originating fax.
 This feature is applicable only if the IsFaxUsed parameter is set
to [1] or [3].