AudioCodes Media 800 MSBR

Version 6.6 871 Mediant 800 MSBR
User's Manual 66. Configuration Parameters Reference
Parameter Description
One Sub Standard
CLI: etsi-callerid-type-one-
sub-standard
[ETSICallerIDTypeOneSu
bStandard]

[0] = (Default) ETSI between rings.
 [1] = ETSI before ring DT_AS.
 [2] = ETSI before ring RP_AS.
 [3] = ETSI before ring LR_DT_AS.
 [4] = ETSI not ring related DT_AS.
 [5] = ETSI not ring related RP_AS.
 [6] = ETSI not ring related LR_DT_AS.
Note: For this parameter to take effect, a device reset is required.
Web: Asserted Identity
Mode
EMS: Asserted ID Mode
CLI: asserted-identity-m
[AssertedIdMode]
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is used in the generated SIP INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers are used to
present the originating party's Caller ID. The Caller ID is composed of
a Calling Number and a Calling Name (optional).
 [0] Disabled = (Default) P-Asserted-Identity nor P-Preferred-Identity
headers are not added.
 [1] Add P-Asserted-Identity
 [2] Add P-Preferred-Identity
The header used also depends on the calling Privacy (allowed or
restricted). These headers are used together with the Privacy header.
If Caller ID is restricted (i.e., P-Asserted-Identity is not sent), the
Privacy header includes the value 'id' ('Privacy: id'). Otherwise, for
allowed Caller ID, 'Privacy: none' is used. If Caller ID is restricted
(received from PSTN / Tel or configured in the device), the From
header is set to <anonymous@anonymous.invalid>.
The 200 OK response can contain the connected party CallerID -
Connected Number and Connected Name. For example, if the call is
answered by the device, the 200 OK response includes the P-
Asserted-Identity with Caller ID. The device interworks (in some ISDN
variants), the Connected Party number and name from Q.931 Connect
message to SIP 200 OK with the P-Asserted-Identity header. In the
opposite direction, if the ISDN device receives a 200 OK with P-
Asserted-Identity header, it interworks it to the Connected party
number and name in the Q.931 Connect message, including its
privacy.
Web/EMS
: Use Destination
As Connected Number
[UseDestinationAsConne
ctedNumber]
Enables the device to include the Called Party Number, from outgoing
Tel calls (after number manipulation), in the SIP P-Asserted-Identity
header. The device includes the SIP P-Asserted-Identity header in 180
Ringing and 200 OK responses for IP-to-Tel calls.
 [0] Disable (default)
 [1] Enable
Notes:
 For this feature, you must also enable the device to include the P-
Asserted-Identity header in 180/200 OK responses, by setting the
parameter AssertedIDMode to Add P-Asserted-Identity.
 If the received Q.931 Connect message contains a Connected
Party Number, this number is used in the P-Asserted-Identity
header in 200 OK response.
 This parameter is applicable to ISDN, CAS, and/or FXO interfaces.
Web: Caller ID Transport
Type
EMS: Transport Type
Determines the device's behavior for Caller ID detection.
 [0] Disable = The caller ID signal is not detected - DTMF digits