AudioCodes Media 800 MSBR

Version 6.6 873 Mediant 800 MSBR
User's Manual 66. Configuration Parameters Reference
Parameter Description
side, FXS only).
 FXS interfaces: The EnableHold parameter must be enabled on
both the calling and the called side.
 Analog interfaces: You can use the table parameter
CallWaitingPerPort to enable Call Waiting per port.
 Analog interfaces: For information on the Call Waiting feature, see
Call Waiting on page 363.
EMS: Send 180 For Call
Waiting
[Send180ForCallWaiting]
Determines the SIP response code for indicating Call Waiting.
 [0] = (Default) Use 182 Queued response to indicate call waiting.
 [1] = Use 180 Ringing response to indicate call waiting.
Call Waiting Table
Web: Call Waiting Table
EMS: SIP Endpoints > Call
Waiting
CLI: configure voip > gw
analoggw call-waiting
[CallWaitingPerPort]
This table parameter configures call waiting per FXS port. The format
of this parameter is as follows:
[CallWaitingPerPort]
FORMAT CallWaitingPerPort_Index = CallWaitingPerPort_IsEnabled,
CallWaitingPerPort_Module, CallWaitingPerPort_Port;
[\CallWaitingPerPort]
For example:
CallWaitingPerPort 0 = 0,1,1; (call waiting disabled for Port 1 of Module
1)
CallWaitingPerPort 1 = 1,1,2; (call waiting enabled for Port 2 of Module
1)
Notes:
 This parameter is applicable only to FXS ports.
 For a detailed description of this table, see Configuring Call Waiting
on page 408.
Web: Number of Call
Waiting Indications
EMS: Call Waiting Number
of Indications
CLI: nb-of-cw-ind
[NumberOfWaitingIndicat
ions]
Defines the number of call waiting indications that are played to the
called telephone that is connected to the device for Call Waiting.
The valid range is 1 to 100 indications. The default is 2.
Note: This parameter is applicable only to FXS ports.
Web: Time Between Call
Waiting Indications
EMS: Call Waiting Time
Between Indications
CLI: time-between-cw
[TimeBetweenWaitingInd
ications]
Defines the time (in seconds) between consecutive call waiting
indications for call waiting.
The valid range is 1 to 100. The default is 10.
Note: This parameter is applicable only to FXS ports.
Web/EMS: Time Before
Waiting Indications
CLI: time-b4-cw-ind
[TimeBeforeWaitingIndic
ations]
Defines the interval (in seconds) before a call waiting indication is
played to the port that is currently in a call.
The valid range is 0 to 100. The default time is 0 seconds.
Note: This parameter is applicable only to FXS ports.
Web/EMS: Waiting Beep
Duration
CLI: waiting-beep-dur
[WaitingBeepDuration]
Defines the duration (in msec) of call waiting indications that are
played to the port that is receiving the call.
The valid range is 100 to 65535. The default is 300.
Note: This parameter is applicable only to FXS ports.