AudioCodes Media 800 MSBR - Page 904

User's Manual 904 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
Web/EMS: B-channel
Negotiation
CLI: b-ch-negotiation
[BchannelNegotiation]
Determines the ISDN B-Channel negotiation mode.
 [0] Preferred
 [1] Exclusive (default)
 [2] Any
Notes:
 This parameter is applicable only to ISDN protocols.
 For some ISDN variants, when 'Any' (2) is selected, the Setup
message excludes the Channel Identification IE.
 The Any' (2) option is applicable only if the following conditions
are met:

The parameter TerminationSide is set to 0 ('User side').

The PSTN protocol type (ProtocolType) is configured as
Euro ISDN.
NFAS Parameters
Note: These parameters are applicable to PRI interfaces.
Web: NFAS Group Number
EMS: Group Number
CLI: isdn-nfas-group-number
[NFASGroupNumber_x]
Defines the ISDN Non-Facility Associated Signaling (NFAS)
group number (NFAS member) per trunk.
 [0] = (Default) Non-NFAS trunk.
 [1] to [12] = NFAS group number.
Trunks that belong to the same NFAS group have the same
number. With NFAS, you can use a single D-channel to control
multiple PRI interfaces.
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only to T1 ISDN protocols.
 The x in the ini file parameter denotes the trunk number,
where 0 is Trunk 1.
 For more information on NFAS, see 'ISDN Non-Facility
Associated Signaling (NFAS)' on page 289.
Web/EMS: D-channel
Configuration
CLI: isdn-nfas-dchannel-type
[DChConfig_x]
Defines primary, backup (optional), and B-channels only, per
trunk.
 [0] PRIMARY= (Default) Primary Trunk - contains a D-channel
that is used for signaling.
 [1] BACKUP = Backup Trunk - contains a backup D-channel
that is used if the primary D-channel fails.
 [2] NFAS = NFAS Trunk - contains only 24 B-channels,
without a signaling D-channel.
Notes:
 This parameter is applicable only to T1 ISDN protocols.
 The x in the ini file parameter denotes the trunk number,
where 0 is Trunk 1.
Web: NFAS Interface ID
EMS: ISDN NFAS Interface ID
CLI: isdn-nfas-interface-id
[ISDNNFASInterfaceID_x]
Defines a different Interface ID per T1 trunk.
The valid range is 0 to 100. The default interface ID equals the
trunk's ID.
Notes:
 To set the NFAS interface ID, configure ISDNIBehavior_x to
include '512' feature per T1 trunk.
 The x in the ini file parameter denotes the trunk number,
where 0 is Trunk 1.